| STEP 1 |
FABRICATE PIPE: a. Install 5(min) evenly spaced eyebolts on pipe facing up (install outside eyebolts 1 foot in on each end. b. Install 2 (tie down) eyebolts on each end facing down. |
| STEP 2 |
CEILING ATTACHMENT: duplicate spacing of eyebolts on pipe to that of the selected ceiling framework and install ceiling hardware attachments on ceiling framework. |
| STEP 3 |
HD NET ATTACHMENT: If you are installing an HD Series Cargo Net with eyeloops on top of net, attach net at this point by sliding pipe through 4 inch ID eyeloops evenly and tie down top corners. If you are hanging a CN series net you can tie net on at this step or wait until pipe is hung as shown in illustration #1 and described in STEP 5 |
| STEP 4 |
CONNECTING PIPE TO CEILING FRAMEWORK: Connect pipe to ceiling via chain or cable. This can be done several different ways: I. Chain A. Determine chain length and attach chain to ceiling hardware via links. Bring pipe up to chain and attach via links. Count chain links to ensure correct and equal lengths. You can adjust height after net is attached by same link counting method. B. Attach chain to pipe via links and bring chain with pipe attached up to ceiling hardware and connect via links. II. Cable A. Using 1/4" ( minimum) flexible cable determine length needed and have an eyeloop on the 5 (minimum) cables swaged or spliced on each end. Attach cable to ceiling hardware via links. Bring pipe up to cable and attach via links. Or use alternative method of attaching pipe first and ceiling hardware last. B. Using 1/4" flexible cable, splice cable directly onto ceiling and pipe eyebolts using 1/4" wire rope clamps. NOTE: you will need extra ( at least 18") cable on each end to make the eyeloop attachment and connection. III Other Methods Nets have been installed using other methods when normal hanging wasn't practical or other methods were designed. Be certain to tie or attach nets to smooth hardware and/or surfaces and inspect these areas routinely. Again, consult an experienced installation engineer. NOTE: All hardware and hanging devices should exceed all loads put on them 2000 pound capacity hardware minimum. Inspections should be made to any and all equipment. If draping chain or cable over open trusses be sure to rub areas and specify flexible (no crimp) cable. A cargo net is a relatively inexpensive piece of equipment and generates countless movement challenges. Be sure to inspect routinely and replace periodically. |
| STEP 5 |
CN NET ATTACHMENT: If installing a CN series cargo net, tie net to pipe as illustrated. Net should touch or drape on floor. Net should drape on mats when placed under net and climbing area. RESPONSIBLE SAFE WORK LOADS allows for at least a 5:1 safety ratio 300 pound per climber 1000 pound per net- proper spotting and supervision for each climber KEEP THESE INSTRUCTIONS AND REVIEW PERIODICALLY Remember to always use appropriate mats under and around all climbing equipment. For further information regarding JAMMAR equipment and/or appropriate matting please contact your dealer or call us at 1-860-848-1113, FAX 1-860-848-9302 |